ASME B16.39:2009 pdf download

ASME B16.39:2009 pdf download.Malleable lron Threaded Pipe Unions. 9 HYDROSTATIC STRENGTH Assembled Unions shall be capable of withstanding, without rupture or leakage through the shell or at the union point, .n internal hydrostatic pre%sLir...

11-11

ASME B16.40:2008 pdf download

ASME B16.40:2008 pdf download.Manually Operated Thermoplastic Gas Shutoffs and Valvesin Gas Distribution Systems. 2.2 Materials 2.2.1 Valve Shell. The pressure-containing valve shell shall be made from either polyethylene (PE) or polyamide 1...

11-11

ASME B16.33:2012 pdf download

ASME B16.33:2012 pdf download.Manually Operated Metallic Gas Valves for Use in Gas Piping Systems Up to 175 psi. 3.2.3.3 Compression Set Tests. Elastomer parts that may be exposed to fuel gas shall be made from materials having a compression...

11-11

ASME B16.36:2006 pdf download

ASME B16.36:2006 pdf download.Orifice Flanges. 8.2.2 IdentifIcation. For ring joint flanges requiring alteration of pressure tap location due to interference with the ring groove other than methods provided in this Standard, such alteration...

11-11

ASME B16.29:2007 pdf download

ASME B16.29:2007 pdf download.Wrought Copper and Wrought Copper Alloy Solder-Joint Drainage Fittings - DWV. 10.3 Threading Tolerances Tapered pipe threads (NPT) shall be checked by use of plug or ring gauges. in either standard or limit type...

11-11

ASME B16.26:2011 pdf download

ASME B16.26:2011 pdf download.Cast Copper Alloy Fittings for Flared Copper Tubes. 2 GENERAL 2.1 References Codes, standards, and specifications containing provisions to the extent referenced herein constitute requirements of this Standard. T...

11-11

ASME B16.24:2011 pdf download

ASME B16.24:2011 pdf download.Cast Copper Alloy Pipe Flanges and Flanged Fittings. 3.4 Rating Temperature The temperature shown for a corresponding pressure- temperature rating is the temperature of the pressure- containing shell of the flan...

11-11

ASME B16.25:2012 pdf download

ASME B16.25:2012 pdf download.Buttwelding Ends. 3 WELDING BEVEL DESIGN 3.1 Bevels foe Other Than GTAW Root Pass (a) Components having nominal wall thicknesses nf 3 mm (0.12 in.) and less shall base ends cut square or slightly chamfered, (b)...

11-11

ASME B16.22:2012 pdf download

ASME B16.22:2012 pdf download.Wrought Copper and Copper Alloy Solder-Joint Pressure Fittings. 9.3 Ovality of Fitting End (C or FIG) Maximum ovality of the fitting solder-joint end shall not exceed 1% of the maximum diameters shown in Table I...

11-11

ASME B16.21:2005 pdf download

ASME B16.21:2005 pdf download.Nonmetallic Flat Gaskets for Pipe Flanges. 1.2 Relevant Units This Standard states values both in metric and U.S. customary units. As an exception, diameter of bolts and flange bolt holes are expressed in inch u...

11-11