ASME A112.14.3:2000 pdf download.GREASE INTERCEPTORS. These motions shall be so regulated as to have the baffle submerged to within I in. (25 mm) of its lop by the time it reaches the end of the last 2 in. (50 mm) of horiiontal travel. The b...
ASME A112.6.3:2001 pdf download.FLOOR AND TRENCH DRAINS. 6.1.3 Leaded Nickel Bronze (Nickel Silver). Castings shall conform to the chemical and mechanical requirements of ASTM B 584 for Copper Alloy Nos. C973(X), C97600, and C99700. The mini...
ASME A112.18.8:2009 pdf download.ln-Line Sanitary Waste Valves for Plumbing Drainage Systems. 3.8.4 Performancr Requirements. At the completion of the above test, the valve shall be tested in accordance with pars. 3.2 and nwet 11w requiremen...
ASME A112.18.3:2002 pdf download.PERFORMANCE REQUIREMENTS FOR BACKFLOW PROTECTION DEVICES AND SYSTEMS IN PLUMBING FIXTURE FTTINGS. The upper confidence limits are based on measured failure rates for devices subjected to the durability tests...
ASME A112.18.2:2005 pdf download.Plumbing waste fittings. 4.6.7.2 Parts The wall thickness of elastomeric tubular parts shall be at least 2.0 mm (0.079 in). 4.6.8 TubIng stops Tubing stops in diversion tees, other tees, and twin waste elbows...
ASME A112.14.4:2001 pdf download.GREASE REMOVAL DEVICES. 3.2.2 Grease Delivery System (Grease Metering Sink. A floor sink of sufficient volume to contain 10% of the rated grease capacity of the GRD being tested shall be connected through a b...
ASME A112.14.6:2006 pdf download.FOG (Fats, Oils,and Greases)Disposal Systems. (a) flow control and/or vent n.quirements (b) any separate trapping tiirements (c) elevation and accessibility requirements (d) safety and health-related instruct...
ASME A112.3.4:2013 pdf download.Plumbing fixtures with pumped waste and macerating toilet systems. 4.2.4 Function The unit shall dispose of the contents of the water closet upon activation of the flushing mechanism. The macerating pump shall...
ASME A112.3.1:2007 pdf download.Stainless Steel Drainage Systems for Sanitary DwV, Storm,and Vacuum Applications, Above-and Below-Ground. 2 REQUIREMENTS 2.1 Dimensions All dimensions for stainless steel pipe, fittings, drains. and adapters a...
ASME A112.4.1:2009 pdf download.Water Heater Relief Valve Drain Tubes. 2.5 Marking and Identification 2.5.1 The manufacturers name or trademark shall be permanently marked on the drain tube. 2.5.2 For pmducts intended for other than OEM appl...
